Toyota Yaris: Vehicle Interior / Seat Belt
TERMINALS OF ECU CHECK POWER DISTRIBUTION BOX ASSEMBLY
(a) Remove the power distribution box assembly. Click here
(b) Reconnect the power distribution box assembly connectors...
ComponentsCOMPONENTS ILLUSTRATION
*1 REAR SEATBACK ASSEMBLY *2 CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...
Other information:
INSTALLATION PROCEDURE 1. INSTALL OIL PRESSURE AND TEMPERATURE SENSOR (a) Apply adhesive to 2 or 3 threads of the oil pressure and temperature sensor. Adhesive: Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent NOTICE:
Do not apply adhesive to the oil inlet port of the oil pressure and temperature sensor...
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly
Dynamic Radar Cruise Control System
Lane Tracing Assist System
Front Radar Sensor System
Pre-collision System
Auto High Beam System
Triangle Target:
Flat Surface Target:
Driving Adjustment:
Update ECU security key Vehicle control history (RoB) are stored
PROCEDURE 1...
Categories
WARNING
Never allow a person to ride in the luggage compartment/trunk
Allowing a person to ride in the luggage compartment/trunk is
dangerous.
The person in the luggage compartment/trunk could be seriously injured or
killed during sudden braking or a collision.
Do not drive with the liftgate/trunk lid open
read more