Toyota Yaris: Seat Belt / Rear Seat Outer Belt Assembly
INSTALLATION PROCEDURE 1. INSTALL REAR SEAT INNER BELT ASSEMBLY LH (a) Install the rear seat inner belt assembly LH with the bolt. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf}
Protruding Part NOTICE: Do not allow the anchor part of the rear seat inner belt assembly LH to overlap the protruding parts of the vehicle body...
COMPONENTS ILLUSTRATION
*1 REAR SEATBACK ASSEMBLY *2 BENCH TYPE REAR SEAT CUSHION ASSEMBLY *3 REAR SEAT CUSHION LOCK HOOK - -
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...
Other information:
INSTALLATION PROCEDURE 1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY (a) Install a new gasket to the fuel tank assembly. (b) Connect the fuel return vent tube sub-assembly to the fuel suction tube with pump and gauge assembly. Click here
*1 Fuel Return Vent Tube Sub-assembly
Front of the Vehicle
Make sure to correctly assemble the fuel return vent tube sub-assembly as shown in the illustration...
SYSTEM DESCRIPTION DESCRIPTION The power steering system generates torque through the operation of the motor and the reduction gear installed on the column shaft in order to assist steering effort. The power steering ECU assembly determines the direction and the amount of assist power in accordance with the vehicle speed signals and signals from the torque sensor built into the electric power steering column sub-assembly...
Categories
The fuel gauge shows approximately how much fuel is remaining in
the tank when the ignition is switched ON. We recommend keeping
the tank over 1/4 full.

Full
1/4 Full
Empty
read more