Toyota Yaris: Vehicle Interior / Pre-collision

Power Outlet Socket

ComponentsCOMPONENTS ILLUSTRATION *1 CENTER LOWER INSTRUMENT COVER *2 LOWER INSTRUMENT PANEL FINISH PANEL *3 SWITCH HOLE BASE SUB-ASSEMBLY *4 SHIFT LEVER KNOB SUB-ASSEMBLY *5 NO...

Pre-collision System

..

Other information:

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Stop and Start System does not Operate (Battery Condition)

DESCRIPTION When the stop and start system does not operate, check whether the operation is prohibited because the auxiliary battery conditions are not met. Data List items Hood Courtesy Switch Auxiliary Battery Current Auxiliary Battery Fluid Temperature (Start) Auxiliary Battery Fluid Temperature Idling Stop Rate Total Idling Stop Rate Integrated Current Status of Auxiliary Battery Charge Control Minimum Voltage (Cranking) Minimum Voltage (Starter Solenoid Engagement) State of BBC Stop&Start Operating Permission (Power Management) Stop&Start Operating Permission (Minimum Voltage (Starter Solenoid Engagement)) Stop&Start Operating Permission (Minimum Voltage (Cranking)) Stop&Start Operating Permission (Integrated Current) Stop&Start Operating Prohibition (Jump Start) Stop&Start Operating Prohibition (Manual Start for the First Time) Auxiliary Battery Type Ambient Temperature Alternator Status NOTICE: If the Data List item Stop&Start Operating Permission (Power Management) is "NG" even after correcting a certain problem using the diagnostic troubleshooting procedures, the problem may be due to the auxiliary battery charge amount being temporarily low or the auxiliary battery may be deteriorated...

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Terminals Of Ecu

TERMINALS OF ECU CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (a) Disconnect the H46 certification ECU (smart key ECU assembly) connector. (b) Measure the voltage and resistance according to the value(s) in the table below. Tester Connection Terminal Description Condition Specified Condition Related Data List Item H46-29 (E) - Body ground Ground Always Below 1 Ω - H46-6 (+B) - H46-29 (E) Power supply Always 11 to 14 V - H45-22 (CUTB) - H46-29 (E) Dark current cut pin* Ignition switch off 11 to 14 V - *: In order to prevent the vehicle auxiliary battery from being depleted when the vehicle is shipped long distances, a fuse that cuts unnecessary electrical load while the vehicle is being shipped is installed in the circuit...