Toyota Yaris: Suspension / Rear Suspension
INSTALLATION PROCEDURE 1. INSTALL FRONT STABILIZER BAR Click here
2. INSTALL STEERING LINK ASSEMBLY Click here
3. TEMPORARILY INSTALL FRONT LOWER NO...
Other information:
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ECM removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
*1: When the ECM is replaced with a new one, reset memory is unnecessary...
Overhead lights/Map lights
Wrap a small flathead screwdriver with a soft cloth to prevent damage to
the lens, and
then remove the lens by
carefully prying on the edge
of the lens with the flathead
screwdriver.
Disconnect the bulb by pulling it out...
Categories
Stop the vehicle completely.
Manual transaxle:
Shift into neutral and set the parking brake.
Automatic transaxle:
Shift the selector lever to the P position and set the parking brake.
Press the push button start to turn off the engine. The ignition position is
off.
read more