Toyota Yaris: Rear Suspension / Rear Lower Arm

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1...

Components

COMPONENTS ILLUSTRATION *1 REAR COIL SPRING *2 REAR LOWER COIL SPRING INSULATOR *3 REAR NO. 2 SUSPENSION ARM ASSEMBLY *4 REAR STABILIZER LINK ASSEMBLY *5 REAR STABILIZER BAR *6 REAR SUSPENSION TOE ADJUST CAM SUB-ASSEMBLY *7 NO...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Steering Angle Sensor Module Component Internal Failure (C052696)

DESCRIPTION The skid control ECU (brake actuator assembly) outputs this DTC when it receives an internal malfunction signal from the steering sensor. DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from C052696 Steering Angle Sensor Module Component Internal Failure With the +BS terminal voltage 9...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR (a) Check the wire harness. (1) Disconnect the automatic light control sensor. (2) Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Connection Switch Condition Specified Condition H78-1 (CLTB) - H78-2 (CLTE) Ignition switch on (IG) 11 to 14 V If the specified condition is not met, replace the vehicle wire harness...