Toyota Yaris: Rear Suspension / Rear Trailing Arm

Installation

INSTALLATION PROCEDURE 1. INSTALL HOLE PLUG (a) Install the 8 hole plugs to the rear suspension member sub-assembly. 2. INSTALL REAR SUSPENSION MEMBER HOLE COVER (a) Install the 4 rear suspension member hole covers to the rear suspension member sub-assembly...

Components

COMPONENTS ILLUSTRATION *1 REAR TRAILING ARM ASSEMBLY *2 REAR STABILIZER LINK ASSEMBLY *3 REAR SPEED SENSOR *4 NO. 3 PARKING BRAKE CABLE ASSEMBLY *5 REAR STABILIZER BAR *6 CAP Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...

Other information:

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Low Pressure Fuel System Pressure - Too Low (P008A00)

DESCRIPTION In order to supply the optimal fuel pressure according to the driving conditions and usage environment, the variable fuel system sends a drive signal from the ECM to the fuel pump control ECU, steplessly performing variable control of the fuel pump (for low pressure side) and receiving feedback about the fuel pressure (for low pressure side) from the No...

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY Click here 2. DISCONNECT UNION TO CONNECTOR TUBE HOSE Click here 3. OPERATION CHECK (a) Connect the hose of the vacuum gauge to the vacuum pump assembly. *a Vacuum Gauge *b Plug (b) Start the engine and warm it up for more than 2 minutes...