Toyota Yaris: Rear Suspension / Rear Shock Absorber
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1...
COMPONENTS ILLUSTRATION
*1 REAR SHOCK ABSORBER ASSEMBLY *2 REAR STABILIZER LINK ASSEMBLY *3 REAR UPPER CONTROL ARM ASSEMBLY *4 REAR STABILIZER BAR *5 CAP - -
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...
Other information:
TOUCH & TAP
Touch or tap on the item indicated on the screen.
The operation is launched and the next item is
displayed.
SLIDE
Touch the setting item displaying a slider bar.
Touch the slider with your finger and move to the desired
level...
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pump removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Replaced Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link Replacement of fuel pump Inspection after repair
Poor idle, etc...
Categories
The front and side supplemental restraint systems (SRS) include different
types of air bags. Please verify the different types of air bags
which are equipped on your vehicle by locating the “SRS AIRBAG”
location indicators. These indicators are visible in the area where the
air bags are installed.
The air bags are installed in the following locations:
The steering wheel hub (driver air bag)
The front passenger dashboard (front passenger air bag)
The outboard sides of the front seatbacks (side air bags)
The front and rear window pillars, and the roof edge along both
sides (curtain air bags)
read more