Toyota Yaris: Steering Pad Switch / Installation
INSTALLATION
PROCEDURE
1. INSTALL STEERING PAD SWITCH ASSEMBLY
(a) Engage the 6 pins to install the steering pad switch assembly.
(b) Connect the steering pad switch connector to the spiral cable sub-assembly.
2. INSTALL NO. 1 STEERING WHEEL ORNAMENT
(a) Engage the 3 pins to install the No. 1 steering wheel ornament.
(b) Install the 2 screws.
3. INSTALL HORN BUTTON ASSEMBLY
Click here
INSPECTION PROCEDURE 1. INSPECT STEERING PAD SWITCH ASSEMBLY (w/ Dynamic Radar Cruise Control System) (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below...
PrecautionPRECAUTION HANDLING PRECAUTIONS FOR STEERING SYSTEM (a) Care must be taken when replacing parts. Incorrect replacement may affect the performance of the steering system and result in a driving hazard...
Other information:
DESCRIPTION Refer to DTC C050C1F. Click here
DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from C050C14 Left Rear Wheel Speed Sensor Circuit Short to Ground or Open An open in the speed sensor signal circuit continues for 0...
ReplacementREPLACEMENT PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (a) Turn the ignition switch ON. (b) Operate the compressor under the conditions shown below: Item Condition Operating time 3 minutes or more Temperature setting Max cool Blower speed High Engine Idling A/C switch ON This causes most of the compressor oil from the various components of the A/C system to collect in the compressor...
Categories
The fuel gauge shows approximately how much fuel is remaining in
the tank when the ignition is switched ON. We recommend keeping
the tank over 1/4 full.

Full
1/4 Full
Empty
read more