Toyota Yaris: Rear Suspension / Rear Suspension Member
INSTALLATION PROCEDURE 1. INSTALL REAR STABILIZER BAR (a) Install the rear stabilizer bar to the rear suspension member sub-assembly with the 4 bolts...
COMPONENTS ILLUSTRATION
*1 REAR STABILIZER BAR *2 REAR SUSPENSION MEMBER SUB-ASSEMBLY *3 REAR UPPER CONTROL ARM ASSEMBLY LH *4 REAR UPPER CONTROL ARM ASSEMBLY RH
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...
Other information:
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE FRONT WHEEL Click here
2. DRAIN BRAKE FLUID NOTICE: If brake fluid leaks onto any painted surface, immediately wash it off...
Replacing the fuses on the vehicle’s left side
If the electrical system does not work, first inspect the fuses on the
vehicle’s left side.
Make sure the ignition is switched off, and other switches are off.
Open the fuse panel cover.
Pull the fuse straight out with
the fuse puller provided on
the fuse block located in the
engine compartment...
Categories
Stop the vehicle completely.
Manual transaxle:
Shift into neutral and set the parking brake.
Automatic transaxle:
Shift the selector lever to the P position and set the parking brake.
Press the push button start to turn off the engine. The ignition position is
off.
read more