Toyota Yaris: Vehicle Interior / Power Outlets (int)
INSTALLATION PROCEDURE 1. INSTALL INNER REAR VIEW MIRROR ASSEMBLY (w/o Pre-collision System) (a) Install the inner rear view mirror assembly as shown in the illustration...
ComponentsCOMPONENTS ILLUSTRATION
*1 CENTER LOWER INSTRUMENT COVER *2 LOWER INSTRUMENT PANEL FINISH PANEL *3 SWITCH HOLE BASE SUB-ASSEMBLY *4 SHIFT LEVER KNOB SUB-ASSEMBLY *5 NO...
Other information:
CAUTION / NOTICE / HINT HINT:
Use the following procedure to troubleshoot the wiper and washer system.
*: Use the GTS.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT
2. CUSTOMER PROBLEM ANALYSIS HINT:
In troubleshooting, confirm that the problem symptoms have been accurately identified...
DESCRIPTION This DTC is stored when the combination meter assembly detects a short in a turn signal light circuit. HINT: If there is a short in a turn signal light circuit, all of the turn signal lights in that circuit will not blink. DTC No. Detection Item DTC Detection Condition Trouble Area B150819 Turn Signal/Hazard Flasher Circuit Current Above Threshold Diagnosis Condition:
Auxiliary battery voltage is 10 V or more
Malfunction Status:
Short in turn signal light circuit
Headlight assembly
Headlight unit assembly LH
Headlight unit assembly RH
Wire Harness LH
Wire Harness RH
Outer rear view mirror assembly
Side turn signal light assembly LH
Side turn signal light assembly RH
Rear combination light assembly
Rear turn signal light LED
Harness or connector
Combination meter assembly
WIRING DIAGRAM
CAUTION / NOTICE / HINT NOTICE:
When replacing the combination meter assembly, always replace it with a new one...
Categories
Before refueling, close all the doors, windows, and the liftgate/trunk
lid, and switch the ignition OFF.
To open the fuel-filler lid, pull
the remote fuel-filler lid release.

To remove the fuel-filler cap, turn it counterclockwise.
Attach the removed cap to the
inner side of the fuel-filler lid.
read more