Toyota Yaris: Vehicle Exterior / Door / Hatch

Vehicle Exterior

h..

Back Door

..

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Reassembly

REASSEMBLY PROCEDURE 1. INSTALL SPARK PLUG TUBE HINT: When using a new cylinder head sub-assembly, the spark plug tubes must be replaced. (a) Apply adhesive to a new spark plug tube as shown in the illustration. Adhesive: Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent Standard Application Width: 1...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine unit removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link Engine assembly Cylinder head sub-assembly Camshaft (for intake or exhaust camshaft) Camshaft timing gear assembly Camshaft timing exhaust gear assembly Fuel injector assembly Fuel pump (for low pressure side) Fuel pump assembly (for high pressure side) Fuel pressure sensor (for low pressure side) Fuel pressure sensor (for high pressure side) Spark plug Ignition coil assembly Air intake system parts Exhaust system parts Turbocharger sub-assembly Inspection after repair Poor idle, etc...