Toyota Yaris: Door / Hatch / Hood Lock Control Cable Assembly

Toyota Yaris XP210 (2020-2023) Reapir and Service Manual / Vehicle Exterior / Door / Hatch / Hood Lock Control Cable Assembly

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL HOOD BUMPER CUSHION (a) Rotate clockwise to install the 2 hood bumper cushions. 2. INSTALL HOOD SUPPORT ASSEMBLY (a) Engage the claws to install the hood support assembly...

Components

COMPONENTS ILLUSTRATION *1 RADIATOR UPPER AIR GUIDE PLATE *2 HOOD LOCK CONTROL CABLE ASSEMBLY *3 HOOD LOCK ASSEMBLY *4 HOOD LOCK CONTROL LEVER SUB-ASSEMBLY N*m (kgf*cm, ft...

Other information:

Toyota Yaris XP210 (2020-2023) Reapir and Service Manual: Installation


INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. TEMPORARILY INSTALL REAR AXLE CARRIER SUB-ASSEMBLY (a) Temporarily install the rear axle carrier sub-assembly to the rear upper control arm assembly with the bolt and nut...

Toyota Yaris XP210 (2020-2023) Reapir and Service Manual: Installation


INSTALLATION PROCEDURE 1. INSTALL FRONT EXHAUST PIPE ASSEMBLY (a) Using a vernier caliper, measure the free length of the compression springs. Standard Length 43.0 mm (1.69 in.) Minimum Free Length 41.5 mm (1.63 in.) If the free length is less than the minimum, replace the compression spring...

Categories

Turning the Engine Off

Stop the vehicle completely. Manual transaxle: Shift into neutral and set the parking brake.

Automatic transaxle: Shift the selector lever to the P position and set the parking brake.

Press the push button start to turn off the engine. The ignition position is off.

read more

 
Copyright © 2023 www.toyaris4.com