Toyota Yaris: Engine & Hybrid System / G16e-gts (starting)

Installation

INSTALLATION PROCEDURE 1. INSTALL TIMING CHAIN COVER OIL SEAL Click here 2. INSTALL TIMING CHAIN COVER ASSEMBLY (a) Install 2 new O-rings to the cylinder block sub-assembly...

Engine Switch

ComponentsCOMPONENTS ILLUSTRATION *1 CENTER LOWER INSTRUMENT COVER *2 LOWER INSTRUMENT PANEL FINISH PANEL *3 ENGINE SWITCH - - RemovalREMOVAL PROCEDURE 1...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Power Steering Torque Sensor "A" Signal Compare Failure (C151162,C151187,C151262,C151287)

DESCRIPTION The power steering ECU assembly supplies a voltage of 5 V to the torque sensor (electric power steering column sub-assembly) and monitors the voltage value of the Hall IC inside the torque sensor (electric power steering column sub-assembly) which changes in response to changes in the magnetic flux density (steering torque) detected by the Hall IC, and calculates the assist torque...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side) (a) Connect the GTS to the DLC3. (b) Start the engine. (c) Turn the GTS on. (d) Inspect the camshaft timing oil control solenoid assembly. (1) Enter the following menus: Powertrain / Engine / Active Test / Control the Intake VVT OCV Duty Ratio Bank 1 / Data List / Intake VVT Change Angle Bank 1...