Toyota Yaris: G16e-gts (starting) / Starter
InspectionINSPECTION PROCEDURE 1. INSPECT ST NO. 1 RELAY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below...
COMPONENTS ILLUSTRATION
*1 STARTER ASSEMBLY *2 FLYWHEEL HOUSING SIDE COVER *3 WIRE HARNESS CLAMP BRACKET *4 NO. 5 WATER BY-PASS HOSE *5 NO...
Other information:
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front airbag sensor removal/installation are shown below...
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE FRONT WHEEL Click here
2. DRAIN BRAKE FLUID NOTICE: If brake fluid leaks onto any painted surface, immediately wash it off...
Categories
If a key is left in the vehicle, the functions of the key left in the vehicle
are temporarily suspended to prevent theft of the vehicle.
To restore the functions, press the unlock button on the functions-suspended
key in the vehicle.
read more