Toyota Yaris: Vehicle Interior / Supplemental Restraint Systems
ComponentsCOMPONENTS ILLUSTRATION
*1 TONGUE PLATE STOPPER - - ● Non-reusable part - - ReplacementREPLACEMENT PROCEDURE 1. REMOVE TONGUE PLATE STOPPER (a) Slide the tongue plate above the installation position of the tongue plate stopper, and temporarily hold it with adhesive tape...
ComponentsCOMPONENTS ILLUSTRATION
*1 AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY *2 NO. 2 INSTRUMENT SIDE PANEL RemovalREMOVAL PROCEDURE 1...
Other information:
INSTALLATION PROCEDURE 1. INSPECT COMPRESSOR OIL (a) Remove the suction seal cap. (b) Using a screwdriver with its tip wrapped in protective tape, insert the screwdriver through the suction port and set the VST valve (valve inside suction port) to the open position...
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts...
Categories
WARNING
When removing the fuel-filler cap, loosen the cap slightly and wait
for
any hissing to stop, then remove it
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness
if
ingested. Fuel spray is released when there is pressure in the fuel tank and
the fuel-filler cap is removed too quickly.
read more