Toyota Yaris: Supplemental Restraint Systems / Spiral Cable

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1...

Components

C..

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the stop light switch assembly connector. (b) Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below. Standard Voltage: Tester Connection Condition Specified Condition A63-7 (B) - A63-2 (GND) Always 11 to 14 V A63-6 (B) - A63-2 (GND) Ignition switch on (IG) 11 to 14 V Standard Resistance: Tester Connection Condition Specified Condition A63-2 (GND) - Body ground Always Below 1 Ω If the result is not as specified, repair or replace the wire harness or connector...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Left Front Wheel Speed Sensor Signal Stuck Low (C050023)

DESCRIPTION Refer to DTC C05001F. Click here DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from C050023 Left Front Wheel Speed Sensor Signal Stuck Low Any of the following is detected: When the +BS terminal voltage is 17...