Toyota Yaris: Supplemental Restraint Systems / Airbag System
ComponentsCOMPONENTS ILLUSTRATION
*1 AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY *2 NO. 2 INSTRUMENT SIDE PANEL RemovalREMOVAL PROCEDURE 1...
PRECAUTION CAUTION: Failure to carry out service procedures in the correct sequence could cause SRS parts to unexpectedly deploy and possibly lead to serious injuries...
Other information:
INSTALLATION PROCEDURE 1. INSTALL NO. 2 AIR FUEL RATIO SENSOR (a) Using SST, install the No. 2 air fuel ratio sensor to the front exhaust pipe assembly. SST: 09224-00012 Torque: Specified tightening torque : 44 N·m {449 kgf·cm, 32 ft·lbf} NOTICE: If the No...
DISASSEMBLY PROCEDURE 1. REMOVE BRAKE MASTER CYLINDER RING PIN (a) Secure the brake master cylinder sub-assembly in a vise. NOTICE: Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly. (b) Using a 5 mm pin punch and a hammer, tap out the brake master cylinder ring pin from the brake master cylinder sub-assembly...
Categories
No special break-in is necessary, but a few precautions in the first 600
miles (1,000 km) may add to the performance, economy, and life of
the vehicle.
Do not race the engine.
Do not maintain one constant speed, either slow or fast, for a long
period of time.
Do not drive constantly at full-throttle or high engine rpm for
extended periods of time.
Avoid unnecessary hard stops.
Avoid full-throttle starts.
read more