Toyota Yaris: Airbag System / Dtc Check / Clear

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual / Vehicle Interior / Supplemental Restraint Systems / Airbag System / Dtc Check / Clear

DTC CHECK / CLEAR

DTC CHECK

(a) Turn the ignition switch to ON, and wait for at least 60 seconds.

(b) Check for DTCs by following the prompts on the GTS screen.

Body Electrical > SRS Airbag > Trouble Codes

HINT:

Refer to the GTS operator's manual for further details.

DTC CLEAR

(a) Clear the DTCs by following the prompts on the GTS screen.

Body Electrical > SRS Airbag > Clear DTCs

HINT:

Refer to the GTS operator's manual for further details.

Terminals Of Ecu

TERMINALS OF ECU AIRBAG SENSOR ASSEMBLY Terminal No. Terminal Symbol Destination O24-1 ICR+ Curtain shield airbag assembly RH O24-2 ICR- O24-3 PR- Front seat outer belt assembly RH O24-4 PR+ O24-5 PL+ Front seat outer belt assembly LH O24-6 PL- O24-7 ICL- Curtain shield airbag assembly LH O24-8 ICL+ O24-9 SFR+ Front seat airbag assembly RH O24-10 SFR- O24-15 SFL- Front seat airbag assembly LH O24-16 SFL+ O24-19 BCR- No...

Freeze Frame Data

FREEZE FRAME DATA DESCRIPTION (a) When an airbag system DTC is stored, the airbag sensor assembly stores the current vehicle (ECU, sensor or squib) state as Freeze Frame Data...

Other information:

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Brake Override System

DESCRIPTION When the vehicle is being driven, depressing the accelerator pedal sensor assembly and brake pedal will activate the brake override system to restrict engine output. The conditions for activating the brake override system as well as the items that are controlled are explained below...

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RAIN SENSOR (a) Remove the rain sensor cover. Click here (b) Disconnect the rain sensor connector. (c) Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Connection Condition Specified Condition V9-4 (SIG) - V9-2 (ES) Ignition switch ON 11 to 14 V If the result is not as specified, repair or replace the harness or connector...