Toyota Yaris: Supplemental Restraint Systems / Front Passenger Airbag Assembly

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1...

Components

C..

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Reassembly

REASSEMBLY PROCEDURE 1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY (a) Apply high-temperature grease to the pinion drive lever as shown in the illustration. *1 Starter Center Bearing Clutch Sub-assembly *2 Starter Drive Housing Assembly *3 Pinion Drive Lever *4 Rubber Seal High-temperature Grease (b) Install the pinion drive lever and rubber seal to the starter center bearing clutch sub-assembly...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Inspection

INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Front Wiper Switch Tester Connection Condition Specified Condition z5-14 (MIST) -z5-5 (E) MIST position Below 1 Ω z5-14 (MIST) -z5-5 (E) Except MIST position 10 kΩ or higher z5-10 (W_OFF) - z5-5 (E) OFF position Below 1 Ω z5-10 (W_OFF) - z5-5 (E) Except OFF position 10 kΩ or higher z5-13 (+S) - z5-5 (E) AUTO position Below 1 Ω z5-13 (+S) - z5-5 (E) Except AUTO position 10 kΩ or higher z5-11 (+1) - z5-5 (E) LO position Below 1 Ω z5-11 (+1) - z5-5 (E) Except LO position 10 kΩ or higher z5-12 (+2) - z5-5 (E) HI position Below 1 Ω z5-12 (+2) - z5-5 (E) Except HI position 10 kΩ or higher Front Washer Switch Tester Connection Condition Specified Condition z5-15 (WF) - z5-5 (E) ON position Below 1 Ω z5-15 (WF) - z5-5 (E) OFF position 10 kΩ or higher Auto Sensitivity Adjustment Switch Tester Connection Condition Specified Condition z5-4 (VR) - z5-5 (E) P1 position 1102 to 1218 Ω z5-4 (VR) - z5-5 (E) P2 position 570 to 630 Ω z5-4 (VR) - z5-5 (E) P3 position 256...