Toyota Yaris: Supplemental Restraint Systems / Inspection After Collision
DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations...
INSPECTION PROCEDURE 1. INSPECTION AFTER COLLISION (a) Inspect the SRS parts in table below. CAUTION:
Be sure to read Precaution thoroughly before servicing...
Other information:
DESCRIPTION Refer to DTC P10D311. Click here
DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note P10D315 Charge Air Cooler Temperature Sensor 2 Bank 1 Circuit Short to Battery or Open The output voltage from the intake air temperature sensor is higher than 4...
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT CANISTER (FUEL SUCTION PLATE SUB-ASSEMBLY) (for Fuel Tank Cap Method) (a) Inspect evaporative emission control system. Click here
(b) Check for clogs in the air filter (when not using the GTS). (1) Start the engine...
Categories
Before refueling, close all the doors, windows, and the liftgate/trunk
lid, and switch the ignition OFF.
To open the fuel-filler lid, pull
the remote fuel-filler lid release.

To remove the fuel-filler cap, turn it counterclockwise.
Attach the removed cap to the
inner side of the fuel-filler lid.
read more