Toyota Yaris: Supplemental Restraint Systems / Steering Pad

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Vehicle Interior / Supplemental Restraint Systems / Steering Pad

Installation

INSTALLATION PROCEDURE 1. INSPECT SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY (a) Check that the spiral cable with sensor sub-assembly is center position. OK: The connector is at the top...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear drive shaft assembly removal/installation are shown below...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. The steering lock ECU (steering lock actuator or upper bracket assembly) communicates with the GTS through the certification ECU (smart key ECU assembly) which uses CAN communication...

Categories

Supplemental Restraint System (SRS) Precautions

The front and side supplemental restraint systems (SRS) include different types of air bags. Please verify the different types of air bags which are equipped on your vehicle by locating the “SRS AIRBAG” location indicators. These indicators are visible in the area where the air bags are installed.

The air bags are installed in the following locations:

The steering wheel hub (driver air bag) The front passenger dashboard (front passenger air bag) The outboard sides of the front seatbacks (side air bags) The front and rear window pillars, and the roof edge along both sides (curtain air bags)