Toyota Yaris: Steering Pad / Components

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Vehicle Interior / Supplemental Restraint Systems / Steering Pad / Components

COMPONENTS

ILLUSTRATION

*1

HORN BUTTON ASSEMBLY

-

-

    Steering Pad

    ..

    Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the horn button assembly removal/installation are shown below...

    Other information:

    Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Registration


    REGISTRATION PROCEDURE 1. ECU EXCHANGE NOTICE: When replacing the engine stop and start ECU, make sure to download the number of starter operations (step 1). After replacing the engine stop and start ECU (step 2), write the number of starter operations to the new engine stop and start ECU (step 3)...

    Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Air Vent Temperature does not Change and Right Vent is Different from Left and Vice Versa (Same Left/Right Temperature Setting)


    DESCRIPTION If the temperature of the air that blows from the left and right front registers differs, even though the same temperature is set for both sides, the following factors may be the cause. Symptom Factor Temperature of outlet air is cooler on left or right side (When same temperature set for both sides) Compressor assembly with pulley malfunction Refrigerant volume (low) Mechanical locking of damper and damper link Automatic light control sensor malfunction Harness or connector Temperature of outlet air is warmer on left or right side (When same temperature set for both sides) Mechanical locking of damper and damper link Blockage in heater radiator unit sub-assembly Harness or connector CAUTION / NOTICE / HINT NOTICE: The air conditioning system uses the CAN communication system...

    Categories

    Turning the Engine Off

    Stop the vehicle completely. Manual transaxle: Shift into neutral and set the parking brake.

    Automatic transaxle: Shift the selector lever to the P position and set the parking brake.

    Press the push button start to turn off the engine. The ignition position is off.

    read more

     
    Copyright © 2026 www.toyaris4.com