Toyota Yaris: Supplemental Restraint Systems / Curtain Shield Airbag Assembly

Installation

INSTALLATION CAUTION / NOTICE / HINT NOTICE: After replacing the airbag sensor assembly, make sure to perform ECU configuration. After performing the ECU configuration procedure, make sure to perform the initialization procedure for when the cable has been disconnected and reconnected to the negative (-) auxiliary battery terminal...

Components

COMPONENTS ILLUSTRATION *1 CURTAIN SHIELD AIRBAG ASSEMBLY *2 ROOF SIDE INNER GARNISH CLIP Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation

INSTALLATION PROCEDURE 1. INSTALL STUD BOLT (a) Using an E8 "TORX" socket wrench, install the stud bolt to the turbocharger sub-assembly. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} 2. INSTALL TURBO WATER PIPE GASKET (a) Install the new turbo water pipe gasket to the turbocharger sub-assembly...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Terminals Of Ecu

TERMINALS OF ECU CHECK ECM HINT: The standard voltage, resistance and waveform between each pair of the ECM terminals is shown in the table below. The appropriate conditions for checking each pair of the terminals are also indicated. The result of checks should be compared with the standard voltage, resistance and waveform for each pair of the terminals as displayed in the Specified Condition column...