Toyota Yaris: Curtain Shield Airbag Assembly / Components
COMPONENTS
ILLUSTRATION
| *1 | CURTAIN SHIELD AIRBAG ASSEMBLY | *2 | ROOF SIDE INNER GARNISH CLIP |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the curtain shield airbag assembly removal/installation are shown below...
Other information:
DESCRIPTION If air does not flow from the front registers after the blower switch on the air conditioning control assembly is operated, the following factors may be the cause. Symptom Factor Blower motor does not operate at all
(Air does not blow from registers)
Harness or connector
Air conditioning amplifier assembly malfunction
Blower motor with fan sub-assembly malfunction
Warm-up control
Engine coolant temperature sensor malfunction
PROCEDURE 1...
ComponentsCOMPONENTS ILLUSTRATION
*1 NO. 1 ENGINE UNDER COVER ASSEMBLY *2 ENGINE UNDER COVER LH *3 MANUAL TRANSMISSION FILLER PLUG *4 MANUAL TRANSMISSION DRAIN PLUG *5 GASKET - -
N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1...
Categories
The fuel gauge shows approximately how much fuel is remaining in
the tank when the ignition is switched ON. We recommend keeping
the tank over 1/4 full.

Full
1/4 Full
Empty
read more