Toyota Yaris: Vehicle Interior / Mirror (int)
DESCRIPTION HINT: This circuit is used for the systems connected to terminal +S. This signal is not used for combination meter assembly operation. Combination meter assembly components such as the speedometer operate using data received via CAN communication...
Other information:
Parts LocationPARTS LOCATION ILLUSTRATION
*1 STARTER ASSEMBLY *2 ECM *3 NO. 1 ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK ASSEMBLY - ST NO. 1 RELAY - ST NO. 1 FUSE *4 FUSIBLE LINK BLOCK ASSEMBLY - R/B FR FUSE - R/B RR NO. 1 ILLUSTRATION
*1 ENGINE SWITCH *2 CERTIFICATION ECU *3 CLUTCH START SWITCH ASSEMBLY *4 ENGINE STOP AND START ECU *5 POWER DISTRIBUTION BOX ASSEMBLY - AM2 FUSE - - *a Refer to Service Bulletin for the installation position of the parts...
REASSEMBLY PROCEDURE 1. INSTALL GENERATOR DRIVE END FRAME BEARING (a) Using SST and a press, install a new generator drive end frame bearing. SST: 09950-60011 09951-00470 SST: 09950-70010 09951-07100
(b) Fit the tabs of the retainer plate into the cutouts of the generator drive end frame to install the retainer plate...
Categories
WARNING
When removing the fuel-filler cap, loosen the cap slightly and wait
for
any hissing to stop, then remove it
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness
if
ingested. Fuel spray is released when there is pressure in the fuel tank and
the fuel-filler cap is removed too quickly.
read more