Toyota Yaris: Engine & Hybrid System / G16e-gts (cooling)
TARGET ADJUSTMENT(FLAT SURFACE TARGET) PROCEDURE 1. PREPARATION FOR MILLIMETER WAVE RADAR SENSOR ASSEMBLY ADJUSTMENT (a) Park the vehicle on a level surface where the area in front of the vehicle shown in the illustration is free of metal objects...
ComponentsCOMPONENTS ILLUSTRATION
*1 RESERVE TANK CAP *2 RADIATOR DRAIN COCK PLUG *3 NO. 1 ENGINE UNDER COVER ASSEMBLY - -
N*m (kgf*cm, ft...
Other information:
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR (a) Check the wire harness. (1) Disconnect the automatic light control sensor. (2) Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Connection Switch Condition Specified Condition H78-1 (CLTB) - H78-2 (CLTE) Ignition switch on (IG) 11 to 14 V If the specified condition is not met, replace the vehicle wire harness...
INSTALLATION PROCEDURE 1. INSTALL FRONT STABILIZER BAR (a) Set the front stabilizer bar to the front suspension crossmember sub-assembly. NOTICE: Make sure that the identification mark is positioned on the right side of the vehicle.
*a Identification Mark - -
Front of the Vehicle - - (b) Install the front stabilizer bar to the front suspension crossmember sub-assembly with the 4 bolts...
Categories
WARNING
Never allow a person to ride in the luggage compartment/trunk
Allowing a person to ride in the luggage compartment/trunk is
dangerous.
The person in the luggage compartment/trunk could be seriously injured or
killed during sudden braking or a collision.
Do not drive with the liftgate/trunk lid open
read more