Toyota Yaris: G16e-gts (cooling) / Water Pump
ComponentsCOMPONENTS ILLUSTRATION
*1 WATER INLET WITH THERMOSTAT SUB-ASSEMBLY *2 GASKET
N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part RemovalREMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the water inlet with thermostat sub-assembly removal/installation are shown below...
COMPONENTS ILLUSTRATION
*1 FAN AND GENERATOR V BELT *2 NO. 1 ENGINE UNDER COVER ASSEMBLY *3 AIR CONNECTOR STAY *4 WATER PUMP PULLEY *5 WATER INLET WITH WATER PUMP HOUSING SUB-ASSEMBLY *6 GASKET *7 WATER INLET WITH THERMOSTAT SUB-ASSEMBLY *8 NO...
Other information:
Temperature control dial
This dial controls temperature. Turn it clockwise for hot and
counterclockwise for cold.
Fan control dial
This dial allows variable fan speeds.
The fan has seven speeds.
Mode selector dial
Turn the mode selector dial to select airflow mode...
TERMINALS OF ECU CHECK POWER STEERING ECU ASSEMBLY
*a Component without harness connected (Power Steering ECU Assembly) - - (a) Measure the voltage and resistance according to the value(s) in the table below. NOTICE: When the EPS warning light is illuminated due to a malfunction, the fail-safe function may cause the voltage of the power steering ECU assembly terminals to become 0 V...
Categories
No special break-in is necessary, but a few precautions in the first 600
miles (1,000 km) may add to the performance, economy, and life of
the vehicle.
Do not race the engine.
Do not maintain one constant speed, either slow or fast, for a long
period of time.
Do not drive constantly at full-throttle or high engine rpm for
extended periods of time.
Avoid unnecessary hard stops.
Avoid full-throttle starts.
read more