Toyota Yaris: G16e-gts (cooling) / Cooling Fan Motor
Components
COMPONENTS
ILLUSTRATION
| *1 | FAN | *2 | COOLING FAN MOTOR |
 | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
Removal
REMOVAL
PROCEDURE
1. REMOVE RADIATOR ASSEMBLY
Click here
2. REMOVE FAN
| (a) Remove the 3 screws and fan from the cooling fan motor. |
|
3. REMOVE COOLING FAN MOTOR
| (a) Remove the 3 screws and cooling fan motor from the fan shroud. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL COOLING FAN MOTOR
(a) Install the cooling fan motor to the fan shroud with the 3 screws.
Torque:
3.9 N·m {40 kgf·cm, 35 in·lbf}
2. INSTALL FAN
(a) Install the fan with the 3 screws.
Torque:
3.9 N·m {40 kgf·cm, 35 in·lbf}
3. INSTALL RADIATOR ASSEMBLY
Click here
Coolant
ComponentsCOMPONENTS ILLUSTRATION
*1 RESERVE TANK CAP *2 RADIATOR DRAIN COCK PLUG *3 NO. 1 ENGINE UNDER COVER ASSEMBLY - -
N*m (kgf*cm, ft...
Other information:
Toyota Yaris XP210 (2020-2022) Reapir and Service Manual: Inspection
INSPECTION PROCEDURE 1. INSPECT STEERING PAD SWITCH ASSEMBLY (w/ Dynamic Radar Cruise Control System) (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. *a Component without harness connected (Steering Pad Switch Assembly) *b Up *c Down *d Right *e Left *f OK *g Back *h On/off Hook *i Voice *j Volume+ *k Volume- *l Seek+ *m Seek- *n MODE *o +RES *p -SET *q CANCEL *r Lane Tracing Assist *s Distance Control *t Cruise Control Main Standard Resistance: Tester Connection Condition Specified Condition 3 (AU1) - 10 (EAU) No switch pushed 95 to 105 kΩ 3 (AU1) - 10 (EAU) Seek+ switch pushed Below 2...
Toyota Yaris XP210 (2020-2022) Reapir and Service Manual: Target Adjustment(triangle Target)
TARGET ADJUSTMENT(TRIANGLE TARGET) PROCEDURE 1. PREPARATION FOR MILLIMETER WAVE RADAR SENSOR ASSEMBLY ADJUSTMENT (a) Park the vehicle on a level surface where the area in front of the vehicle shown in the illustration is free of metal objects. *a 5 m (16...
Categories
- Manuals Home
- Toyota Yaris Owners Manual
- Toyota Yaris Service Manual
- Immobilizer System
- Fog Lights
- Headlights
- New on site
- Most important about car
Key Suspend Function
If a key is left in the vehicle, the functions of the key left in the vehicle are temporarily suspended to prevent theft of the vehicle.
To restore the functions, press the unlock button on the functions-suspended key in the vehicle.
