Toyota Yaris: Backup Boost Converter / Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 1 CONVERTER CONTROL BRACKET
(a) Install the No. 1 converter control bracket to the eco run vehicle converter assembly with the 2 bolts.
2. INSTALL ECO RUN VEHICLE CONVERTER ASSEMBLY
(a) Install the eco run vehicle converter assembly with the bolt and nut.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
| (b) Connect the eco run vehicle converter assembly connector and move the lock lever as shown in the illustration to lock the connector. |
|
3. INSTALL FRONT BUMPER ASSEMBLY
Click here
4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Click here
5. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
Components
C..
Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings...
Other information:
Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Invalid Data Received from ECM/PCM "A" Invalid Serial Data Received (U040181)
DESCRIPTION If the ECM cannot recognize the millimeter wave radar sensor assembly. DTC U040181 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from U040181 Invalid Data Received from ECM/PCM "A" Invalid Serial Data Received Approximately 17 seconds or more after the ignition switch is turned to ON, the ECM cannot recognize the millimeter wave radar sensor assembly for approximately 5 seconds or more...
Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Crankshaft Position Sensor "A" Signal Compare Failure (P033562)
DESCRIPTION These DTCs are stored when the engine speed signal sent by the ECM via direct line and the engine speed signal sent via CAN communication do not match. DTC No. Detection Item DTC Detection Condition Trouble Area Note P033562 Crankshaft Position Sensor "A" Signal Compare Failure The engine speed signal sent by the ECM via direct line and the engine speed signal sent via CAN communication do not match...
Categories
- Manuals Home
- Toyota Yaris Owners Manual
- Toyota Yaris Service Manual
- Brake System Control Module "A" System Voltage System Voltage Low (C137BA2)
- Headlights
- Immobilizer System
- New on site
- Most important about car
Fuel-Filler Lid and Cap
WARNING
When removing the fuel-filler cap, loosen the cap slightly and wait for any hissing to stop, then remove it
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness if ingested. Fuel spray is released when there is pressure in the fuel tank and the fuel-filler cap is removed too quickly.
