Toyota Yaris: Air Conditioning System / Initialization

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual / Vehicle Interior / Heating / Air Conditioning / Air Conditioning System / Initialization

INITIALIZATION

SERVO MOTOR INITIALIZATION

(a) Press the OFF switch.

(b) According to the GTS display, perform servo motor initialization.

Body Electrical > Air Conditioner > Utility

Tester Display
Servomotor Initialization

HINT:

When initialization is started, the AUTO switch indicator will illuminate and then will turn off when initialization has completed.

Customize Parameters

CUSTOMIZE PARAMETERS CUSTOMIZE AIR CONDITIONING SYSTEM (a) Customizing with the GTS. NOTICE: When the customer requests a change in a function, first make sure that the function can be customized...

Utility

UTILITY REFRIGERANT SHORTAGE CHECK USING GTS (a) Check that the following conditions are met and perform the refrigerant shortage check according to the display on the GTS...

Other information:

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the air conditioning amplifier assembly removal/installation are shown below...

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR (a) Check the wire harness. (1) Disconnect the automatic light control sensor. (2) Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Connection Switch Condition Specified Condition H78-1 (CLTB) - H78-2 (CLTE) Ignition switch on (IG) 11 to 14 V If the specified condition is not met, replace the vehicle wire harness...