Toyota Yaris: Vehicle Exterior / Mirror (ext)

Installation

INSTALLATION PROCEDURE 1. INSTALL STEERING WHEEL SWITCH HOUSING (a) When reusing the steering wheel switch housing: (1) Using pliers, expand the clamp and temporarily install the steering wheel switch housing as shown in the illustration...

Outer Mirror Switch

..

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Ecu Configuration

ECU CONFIGURATION STABILIZE A POWER SOURCE ON THE VEHICLE SIDE Shut off as many following systems and parts as possible since they would generate an electrical load. CAUTION: If vehicle systems affect a voltage to reduce during reprogramming, it may disable the ECU in reprogramming, which concludes an ECU replacement...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine unit removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link Engine assembly Cylinder head sub-assembly Camshaft (for intake or exhaust camshaft) Camshaft timing gear assembly Camshaft timing exhaust gear assembly Fuel injector assembly Fuel pump (for low pressure side) Fuel pump assembly (for high pressure side) Fuel pressure sensor (for low pressure side) Fuel pressure sensor (for high pressure side) Spark plug Ignition coil assembly Air intake system parts Exhaust system parts Turbocharger sub-assembly Inspection after repair Poor idle, etc...