Toyota Yaris: Mirror (ext) / Power Mirror Control System
ComponentsCOMPONENTS ILLUSTRATION
*1 OUTER MIRROR - - RemovalREMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side...
PARTS LOCATION ILLUSTRATION
*1 OUTER REAR VIEW MIRROR ASSEMBLY LH - OUTER MIRROR LH *2 OUTER REAR VIEW MIRROR ASSEMBLY RH - OUTER MIRROR RH *3 OUTER MIRROR SWITCH ASSEMBLY *4 NO...
Other information:
INSPECTION PROCEDURE 1. INSPECT FRONT DRIVE SHAFT ASSEMBLY (a) Check that there is no excessive play in the radial direction of the outboard joint.
(b) Check that the inboard joint slides smoothly in the thrust direction. (c) Check that there is no excessive play in the radial direction of the inboard joint...
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the knock sensor removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of throttle body with motor assembly
Cleaning the deposits from the throttle body with motor assembly
Air leaks from intake system
Replacement of knock control sensor
Inspection after repair
Poor idle, etc...
Categories
WARNING
When removing the fuel-filler cap, loosen the cap slightly and wait
for
any hissing to stop, then remove it
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness
if
ingested. Fuel spray is released when there is pressure in the fuel tank and
the fuel-filler cap is removed too quickly.
read more