Toyota Yaris: Vehicle Interior / Door Lock
ComponentsCOMPONENTS ILLUSTRATION
*1 BACK DOOR TRIM BOARD *2 BACK DOOR LOCK ASSEMBLY W/COURTESY LIGHT SWITCH
N*m (kgf*cm, ft.*lbf): Specified torque
MP grease RemovalREMOVAL PROCEDURE 1...
Other information:
DESCRIPTION The ECM communicates with the generator assembly via LIN communication. If a LIN communication error is detected, the ECM stores this DTC. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note P161A87 Lost Communication with Alternator Missing Message Generator assembly or ECM communication stops for approximately 17 minutes or more with the ignition switch ON (1 trip detection logic)
Wire harness or connector
Generator assembly
ECM
Comes on SAE Code: P161A WIRING DIAGRAM
CAUTION / NOTICE / HINT NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure...
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the driver side and front passenger side.
The procedure listed below is for the driver side.
PROCEDURE 1. INSTALL FRONT SEAT INNER BELT ASSEMBLY (for Driver Side) (a) Install the front seat belt anchor plate...
Categories
Before refueling, close all the doors, windows, and the liftgate/trunk
lid, and switch the ignition OFF.
To open the fuel-filler lid, pull
the remote fuel-filler lid release.

To remove the fuel-filler cap, turn it counterclockwise.
Attach the removed cap to the
inner side of the fuel-filler lid.
read more