Toyota Yaris: Door Lock / Power Door Lock Control System
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
PROCEDURE 1...
PRECAUTION PRECAUTIONS WHEN USING GTS (a) When using the GTS with the ignition switch off to troubleshoot: Connect the GTS to the vehicle, and turn a courtesy light switch on and off at 1...
Other information:
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT COOLER CONDENSER ASSEMBLY (a) If the cooler condenser assembly fins are dirty, clean them with water and dry them with compressed air. NOTICE: Do not damage the cooler condenser assembly fins. (b) If any cooler condenser assembly fins are bent, straighten them using a screwdriver or pliers...
DESCRIPTION This DTC is stored when LIN communication between the certification ECU (smart key ECU assembly) and steering lock ECU (steering lock actuator or upper bracket assembly) stops for 10 seconds or more. DTC No. Detection Item DTC Detection Condition Trouble Area B278588 Communication between ECUs connected by LIN Bus off No communication between steering lock ECU (steering lock actuator or upper bracket assembly) and certification ECU (smart key ECU assembly) for 10 seconds or more...
Categories
Before refueling, close all the doors, windows, and the liftgate/trunk
lid, and switch the ignition OFF.
To open the fuel-filler lid, pull
the remote fuel-filler lid release.

To remove the fuel-filler cap, turn it counterclockwise.
Attach the removed cap to the
inner side of the fuel-filler lid.
read more