Toyota Yaris: Power Door Lock Control System / Precaution

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Vehicle Interior / Door Lock / Power Door Lock Control System / Precaution

PRECAUTION

PRECAUTIONS WHEN USING GTS

(a) When using the GTS with the ignition switch off to troubleshoot:

Connect the GTS to the vehicle, and turn a courtesy light switch on and off at 1.5 seconds intervals until communication between the GTS and vehicle begins.

(b) After all DTCs are cleared, check if the malfunction occurs again 6 seconds after the ignition switch is turned to ON.

PRECAUTION WHEN REPLACING MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

(a) If the main body ECU (multiplex network body ECU) is replaced, refer to the Registration.

Click here

PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

(a) After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click here

Power Door Lock Control System

Parts Location

PARTS LOCATION ILLUSTRATION *1 FRONT DOOR LOCK WITH MOTOR ASSEMBLY RH *2 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY RH *3 FRONT DOOR LOCK WITH MOTOR ASSEMBLY LH *4 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH *5 BACK DOOR OPENER SWITCH ASSEMBLY *6 BACK DOOR LOCK ASSEMBLY WITH COURTESY LIGHT SWITCH ILLUSTRATION *1 MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY *2 DOOR CONTROL SWITCH *3 MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *4 POWER DISTRIBUTION BOX ASSEMBLY - ECU-IGR NO...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Power Steering ECU Communication Stop Mode

DESCRIPTION Detection Item Symptom Trouble Area Power Steering ECU Communication Stop Mode Communication stop for "Power Steering (EPS)" is indicated on the "Communication Bus Check" screen of the GTS. Click here Power steering ECU assembly main line or connector Power source circuit of power steering ECU assembly Power steering ECU assembly ground circuit Power steering ECU assembly WIRING DIAGRAM CAUTION / NOTICE / HINT CAUTION: When performing the confirmation driving pattern, obey all speed limits and traffic laws...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Multi-axis Acceleration Sensor Module "A" Supply Voltage Circuit Voltage Out of Range (C14D71C)

DESCRIPTION The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. This DTC is stored when the skid control ECU (brake actuator assembly) receives a sensor supply voltage malfunction signal from the acceleration sensor (airbag sensor assembly)...