Toyota Yaris: Door Lock / Wireless Door Lock Control System
ComponentsCOMPONENTS ILLUSTRATION
*1 WIRELESS DOOR LOCK BUZZER - - RemovalREMOVAL PROCEDURE 1. REMOVE FRONT FENDER LINER LH HINT: Use the same procedure as for front fender liner RH...
PRECAUTION PRECAUTIONS WHEN USING GTS (a) When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1...
Other information:
INSTALLATION PROCEDURE 1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY (a) Install a new gasket to the fuel tank assembly. (b) Connect the fuel return vent tube sub-assembly to the fuel suction tube with pump and gauge assembly. Click here
*1 Fuel Return Vent Tube Sub-assembly
Front of the Vehicle
Make sure to correctly assemble the fuel return vent tube sub-assembly as shown in the illustration...
DESCRIPTION The engine stop and start ECU can detect open circuits when signals such as the boost, standby request or overheating signal cannot be sent to the backup boost converter control IC from the stop and start control IC in the engine stop and start ECU...
Categories
The front and side supplemental restraint systems (SRS) include different
types of air bags. Please verify the different types of air bags
which are equipped on your vehicle by locating the “SRS AIRBAG”
location indicators. These indicators are visible in the area where the
air bags are installed.
The air bags are installed in the following locations:
The steering wheel hub (driver air bag)
The front passenger dashboard (front passenger air bag)
The outboard sides of the front seatbacks (side air bags)
The front and rear window pillars, and the roof edge along both
sides (curtain air bags)
read more