Toyota Yaris: Engine & Hybrid System / G16e-gts (lubrication)

Installation

INSTALLATION PROCEDURE 1. INSTALL STUD BOLT (a) Using an E8 "TORX" socket wrench, install the stud bolt to the turbocharger sub-assembly. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} 2...

Engine Oil Cooler

ComponentsCOMPONENTS ILLUSTRATION *1 OIL COOLER ASSEMBLY *2 OIL COOLER GASKET *3 NO. 5 WATER BY-PASS HOSE *4 OIL FILLER CAP ASSEMBLY *5 GASKET *6 OIL PAN DRAIN PLUG *7 NO...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Relay

On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HORN RELAY ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher 3 - 5 Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the horn relay assembly...

Toyota Yaris XP210 (2020-2026) Owner's Manual: Using LATCH Lower Anchor

Your Toyota is equipped with LATCH lower anchors for attachment of specially designed LATCH child-restraint systems in the rear seats. Both anchors must be used, otherwise the seat will bounce around and put the child in danger. Most LATCH child-restraint systems must also be used in conjunction with a tether to be effective...