Toyota Yaris: G16e-gts (lubrication) / Oil Pressure And Temperature Sensor

Oil And Oil Filter

ComponentsCOMPONENTS ILLUSTRATION *1 OIL FILTER SUB-ASSEMBLY *2 OIL FILLER CAP SUB-ASSEMBLY *3 GASKET *4 OIL PAN DRAIN PLUG *5 REAR ENGINE UNDER COVER RH - - Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...

Components

COMPONENTS ILLUSTRATION *1 OIL PRESSURE AND TEMPERATURE SENSOR *2 NO. 1 ENGINE UNDER COVER ASSEMBLY Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Problem Symptoms Table

PROBLEM SYMPTOMS TABLE Stop and Start System Symptom Suspected Area Link Stop and start system does not operate Refer to "Stop and Start System does not Operate" Refer to "Stop and Start System does not Operate (Battery Condition)" Restarting after a short period of time from an idling stop Refer to "Restarting after a Short Period of Time from an Idling Stop" After engine stops due to stop and start system, engine does not restart Refer to "After Engine Stops due to Stop and Start System, Engine does not Restart" Failure to restart from IG-ON engine stall Refer to "Failure to Restart from IG-ON Engine Stall" Stop and start cancel indicator does not operate Combination meter assembly Indicator circuit (CAN communication system) Engine stop and start ECU Stop and start indicator does not operate Combination meter assembly Indicator circuit (CAN communication system) Engine stop and start ECU Stop and start control cannot be canceled ECAN terminal voltage Stop and start cancel switch circuit Multi-information display screen does not change after pressing steering pad switch assembly...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation

INSTALLATION PROCEDURE 1. INSTALL CAMSHAFT POSITION SENSOR (for Intake Side) (a) Clean the O-ring groove of the camshaft position sensor. NOTICE: Make sure the O-ring groove is free of foreign matter. (b) Install a new O-ring to the camshaft position sensor...