Toyota Yaris: Vehicle Interior / Meter / Gauge / Display

Room Light Bulb

ReplacementREPLACEMENT PROCEDURE 1. REMOVE NO. 1 ROOM LIGHT BULB (a) Using a screwdriver with its tip wrapped in protective tape, disengage the claws to remove the No...

Combination Meter

..

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation

INSTALLATION PROCEDURE 1. INSTALL REAR DIFFERENTIAL SUPPORT (a) Install the differential support to the rear differential carrier assembly with 3 new bolts. Torque: 120 N·m {1224 kgf·cm, 89 ft·lbf} 2. INSTALL REAR DIFFERENTIAL DYNAMIC DAMPER (a) Install the rear differential dynamic damper to the differential support with 2 bolts...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Stop and Start System does not Operate (Battery Condition)

DESCRIPTION When the stop and start system does not operate, check whether the operation is prohibited because the auxiliary battery conditions are not met. Data List items Hood Courtesy Switch Auxiliary Battery Current Auxiliary Battery Fluid Temperature (Start) Auxiliary Battery Fluid Temperature Idling Stop Rate Total Idling Stop Rate Integrated Current Status of Auxiliary Battery Charge Control Minimum Voltage (Cranking) Minimum Voltage (Starter Solenoid Engagement) State of BBC Stop&Start Operating Permission (Power Management) Stop&Start Operating Permission (Minimum Voltage (Starter Solenoid Engagement)) Stop&Start Operating Permission (Minimum Voltage (Cranking)) Stop&Start Operating Permission (Integrated Current) Stop&Start Operating Prohibition (Jump Start) Stop&Start Operating Prohibition (Manual Start for the First Time) Auxiliary Battery Type Ambient Temperature Alternator Status NOTICE: If the Data List item Stop&Start Operating Permission (Power Management) is "NG" even after correcting a certain problem using the diagnostic troubleshooting procedures, the problem may be due to the auxiliary battery charge amount being temporarily low or the auxiliary battery may be deteriorated...