Toyota Yaris: Meter / Gauge / Display / Meter / Gauge System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- Customize Parameters
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- On-vehicle Inspection
- Fuel Sender Circuit Open (B150013,B150113)
- Turn Signal Light Circuit Current Below Threshold (B150718)
- Turn Signal/Hazard Flasher Circuit Current Above Threshold (B150819)
- Lost Communication With ECM/PCM "A" Missing Message (U010087,U011487,U012987,U013187,U014087,U015187,U016887,U023587,U023A87,U111287,U113387)
- Entire Combination Meter does not Operate
- Speedometer Malfunction
- Tachometer Malfunction
- Fuel Receiver Gauge Malfunction
- Engine Coolant Temperature Receiver Gauge Malfunction
- Meter Illumination is Always Dark
- Meter Illumination does not Dim at Night
- Steering Pad Switch Circuit
- Speed Signal Circuit
DESCRIPTION The meter mirror sub-assembly communicates with each ECU via CAN communication. DTC No. Detection Item DTC Detection Condition Trouble Area U010087 Lost Communication With ECM/PCM "A" Missing Message Diagnosis Condition:
The ignition switch is ON
IG power source voltage is 9...
PRECAUTION PRECAUTION FOR REPLACING COMBINATION METER ASSEMBLY When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored...
Other information:
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY Click here
2. REMOVE HEADLIGHT ASSEMBLY (a) Apply protective tape around the headlight assembly as shown in the illustration...
DIAGNOSIS SYSTEM EURO-OBD (EUROPEAN SPEC)
When troubleshooting Europe On-Board Diagnostic (Euro-OBD) vehicles, an OBD scan tool (complying with ISO 15765-4) must be connected to the vehicle. Various data output from the vehicle's ECM can then be read...
Categories
Stop the vehicle completely.
Manual transaxle:
Shift into neutral and set the parking brake.
Automatic transaxle:
Shift the selector lever to the P position and set the parking brake.
Press the push button start to turn off the engine. The ignition position is
off.
read more