Toyota Yaris: Meter / Gauge System / Initialization

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Vehicle Interior / Meter / Gauge / Display / Meter / Gauge System / Initialization

INITIALIZATION

MAINTENANCE REQUIRED REMINDER RESET PROCEDURE

(a) Perform initialization using the multi-information display.

(1) Turn the ignition switch ON.

(2) Select the settings tab.

(3) Enter the following menus: Vehicle Settings / Scheduled Maintenance.

(4) Perform initialization according to the multi-information display.

Customize Parameters

CUSTOMIZE PARAMETERS NOTICE: When the customer requests a change in a function, first make sure that the function can be customized. Be sure to make a note of the current settings before customizing...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Components

COMPONENTS ILLUSTRATION *1 NO. 2 AIR DUCT *2 COOLER PIPE GROMMET *3 COOLER EXPANSION VALVE *4 HEATER CLAMP *5 HEATER RADIATOR UNIT SUB-ASSEMBLY *6 NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY *7 NO. 1 COOLER THERMISTOR *8 UPPER HEATER CASE *9 O-ring *10 LOWER HEATER CASE N*m (kgf*cm, ft...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Refrigerant Pressure Sensor Circuit Short to Ground (P053011)

DESCRIPTION The air conditioner pressure sensor, which is installed to the high pressure side pipe to detect refrigerant pressure, sends a refrigerant pressure signal to the air conditioning amplifier assembly. The air conditioning amplifier assembly converts this signal to a pressure value according to the sensor characteristics and uses it to control the compressor...