Toyota Yaris: Meter / Gauge System / Customize Parameters

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Vehicle Interior / Meter / Gauge / Display / Meter / Gauge System / Customize Parameters

CUSTOMIZE PARAMETERS

NOTICE:

When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.

HINT:

The following items can be customized.

CUSTOMIZE METER / GAUGE SYSTEM

(a) Customizing with the GTS

(1) Select the setting by referring to the table below.

Warning

Tester Display	Description	Default	Setting	ECU
Lane Change Flashing Times Adjust	Function to change the lane change flashing time	3	$00:OFF,$01:3,$02:4,$03:5,$04:6,$05:7	Combination meter assembly
Flasher Sound Volume Adjust	Function to change the turn signal flasher buzzer sound volume	Medium	$02:Large,$00:Medium,$01:Small	Combination meter assembly
Reverse Buzzer Setting	Function to change the reverse buzzer setting	Single	$00:Continual,$01:Single	Combination meter assembly

Display

Tester Display	Description	Default	Setting	ECU
ODO Display Time After IG OFF Adjust	Function to change the trip result display time after the ignition switch is turned off	30s	$00:30s,$01:60s,$02:600s,$03:OFF	Combination meter assembly

How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the meter / gauge system. *: Use the GTS. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT 2...

Initialization

INITIALIZATION MAINTENANCE REQUIRED REMINDER RESET PROCEDURE (a) Perform initialization using the multi-information display. (1) Turn the ignition switch ON...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake manifold removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Replaced Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link Cleaning the deposits from the throttle body with motor assembly Inspection After Repair Poor idle, etc...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation

INSTALLATION PROCEDURE 1. INSTALL BRAKE BOOSTER GASKET (a) Install a new brake booster gasket to the brake booster assembly. 2. INSTALL BRAKE BOOSTER ASSEMBLY (a) Temporarily install the brake booster assembly to the vehicle body. NOTICE: Do not apply excessive force to the brake lines...