Toyota Yaris: Meter / Gauge System / Dtc Check / Clear
DTC CHECK / CLEAR
CHECK FOR DTC
(a) Check for DTCs.
Body Electrical > Combination Meter > Trouble Codes
CLEAR DTC
(a) Clear the DTCs.
Body Electrical > Combination Meter > Clear DTCs
TERMINALS OF ECU COMBINATION METER ASSEMBLY
(a) Measure the voltage and resistance and check for pulses according to the value(s) in the table below...
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not...
Other information:
INSTALLATION CAUTION / NOTICE / HINT NOTICE: After performing the update ECU security key procedure, make sure to perform the initialization procedure for when the cable has been disconnected and reconnected to the negative (-) auxiliary battery terminal...
INSTALLATION PROCEDURE 1. INSTALL ROOF HEADLINING (a) Tilt the roof headlining diagonally and insert it into the cabin through the passenger side door as shown in the illustration.
Insert in this Direction NOTICE:
Check that the corners of the roof headlining are not folded, twisted or otherwise deformed and that none of the mounted parts have fallen off...
Categories
The front and side supplemental restraint systems (SRS) include different
types of air bags. Please verify the different types of air bags
which are equipped on your vehicle by locating the “SRS AIRBAG”
location indicators. These indicators are visible in the area where the
air bags are installed.
The air bags are installed in the following locations:
The steering wheel hub (driver air bag)
The front passenger dashboard (front passenger air bag)
The outboard sides of the front seatbacks (side air bags)
The front and rear window pillars, and the roof edge along both
sides (curtain air bags)
read more