Toyota Yaris: Engine & Hybrid System / G16e-gts (intake / Exhaust)

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Engine & Hybrid System / G16e-gts (intake / Exhaust)

Installation

INSTALLATION PROCEDURE 1. INSTALL CHARCOAL CANISTER OUTLET HOSE (a) Engage the clamp to install the charcoal canister outlet hose to the fuel tank assembly...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Lubrication System

On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. CHECK ENGINE OIL LEVEL (a) Warm up and stop the engine, then wait for 5 minutes. (b) Check that the engine oil level is between the low level and full level marks on the engine oil level dipstick...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the knock sensor removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link Replacement of throttle body with motor assembly Cleaning the deposits from the throttle body with motor assembly Air leaks from intake system Replacement of knock control sensor Inspection after repair Poor idle, etc...

Categories

Break-In Period

No special break-in is necessary, but a few precautions in the first 600 miles (1,000 km) may add to the performance, economy, and life of the vehicle.

Do not race the engine. Do not maintain one constant speed, either slow or fast, for a long period of time. Do not drive constantly at full-throttle or high engine rpm for extended periods of time. Avoid unnecessary hard stops. Avoid full-throttle starts.