Toyota Yaris: G16e-gts (intake / Exhaust) / Turbocharger
ComponentsCOMPONENTS ILLUSTRATION
*1 RADIATOR SUPPORT SUB-ASSEMBLY UPPER *2 FRONT RADIATOR SIDE AIR GUIDE PLATE RH *3 FRONT RADIATOR SIDE AIR GUIDE PLATE LH *4 COOL AIR INTAKE DUCT *5 NO...
PRECAUTION MAINTENANCE PRECAUTION (a) If the turbocharger sub-assembly is found to be defective, it must be replaced. Make sure to identify the cause of the problem including the conditions under which the turbocharger sub-assembly was used...
Other information:
COMPONENTS ILLUSTRATION
*1 MANUAL TRANSAXLE ASSEMBLY *2 TRANSFER ASSEMBLY *3 TRANSFER AND TRANSAXLE SETTING STUD BOLT - -
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...
REASSEMBLY PROCEDURE 1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY (a) Apply high-temperature grease to the pinion drive lever as shown in the illustration.
*1 Starter Center Bearing Clutch Sub-assembly *2 Starter Drive Housing Assembly *3 Pinion Drive Lever *4 Rubber Seal
High-temperature Grease (b) Install the pinion drive lever and rubber seal to the starter center bearing clutch sub-assembly...
Categories
The front seat belt pretensioners are designed to deploy in moderate or
severe frontal, near frontal collisions.
In addition, the pretensioners operate when a side collision or a rollover
accident is detected. The pretensioners operate differently
depending on what types of air bags are equipped. For more details
about the seat belt pretensioner operation, refer to the SRS Air Bag
Deployment Criteria.
read more