Toyota Yaris: G16e-gts (intake / Exhaust) / Intake System

Installation

INSTALLATION PROCEDURE 1. INSTALL MANIFOLD TO CYLINDER HEAD GASKET (a) Install a new No. 1 intake manifold to head gasket to the intake manifold. 2. INSTALL THROTTLE WITH THROTTLE POSITION SENSOR BODY ASSEMBLY (a) Install the new gaskets to throttle with throttle position sensor body assembly...

On-vehicle Inspection

ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced when repairing air leaks in the intake system are shown below...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: VIN Not Programmed (P063051)

MONITOR DESCRIPTION DTC P063051 is stored when the Vehicle Identification Number (VIN) is not stored in the ECM or the stored VIN is not accurate. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note P063051 VIN Not Programmed Either of the following conditions is met (1 trip detection logic): The VIN is not stored in the ECM...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Crankshaft Position Sensor "A" Signal Compare Failure (P033562)

DESCRIPTION The crankshaft position sensor sends an engine speed signal (NE signal) to the ECM. The engine speed signal is then sent directly from the NEO terminal of the ECM to the engine stop and start ECU. Additionally, the ECM sends the engine speed to the engine stop and start ECU via CAN communication...