Toyota Yaris: Seat Heater Switch / Installation
INSTALLATION
PROCEDURE
1. INSTALL SEAT HEATER SWITCH
| (a) Engage the claws to install the seat heater switch. HINT: Use the same procedures for the opposite side. | |
2. INSTALL SWITCH HOLE BASE SUB-ASSEMBLY
Click here
INSPECTION PROCEDURE 1. INSPECT SEAT HEATER SWITCH (for LH Side) (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below...
Other information:
DESCRIPTION If the airflow from the front registers is weak regardless of the blower speed setting displayed on the air conditioning control assembly, the following factors may be the cause. Symptom Factor
Airflow volume is constantly low
Airflow volume sometimes becomes low
ECO mode control of air conditioning system is enabled
Harness or connector
Air conditioning amplifier assembly
Blower motor with fan sub-assembly malfunction
Clogged clean air filter
Clogged No...
CHECK FOR INTERMITTENT PROBLEMS CHECK FOR INTERMITTENT PROBLEMS HINT: A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected using the Data List function of the GTS. (a) Follow the directions on the GTS to display the Data List and select areas where momentary interruption should be monitored...
Categories
If a key is left in the vehicle, the functions of the key left in the vehicle
are temporarily suspended to prevent theft of the vehicle.
To restore the functions, press the unlock button on the functions-suspended
key in the vehicle.
read more