Toyota Yaris: Seat / Seat Heater System
INSTALLATION PROCEDURE 1. INSTALL SEAT HEATER SWITCH (a) Engage the claws to install the seat heater switch. HINT: Use the same procedures for the opposite side...
Other information:
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RAIN SENSOR (a) Remove the rain sensor cover. Click here
(b) Disconnect the rain sensor connector. (c) Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Connection Condition Specified Condition V9-4 (SIG) - V9-2 (ES) Ignition switch ON 11 to 14 V If the result is not as specified, repair or replace the harness or connector...
COMPONENTS ILLUSTRATION
*1 FUEL TUBE SUB-ASSEMBLY *2 HEATER WATER HOSE INLET *3 HEATER WATER HOSE OUTLET *4 NO. 2 AIR HOSE *5 NO. 5 AIR HOSE *6 NO. 6 WATER BY-PASS HOSE *7 NO. 5 WATER BY-PASS HOSE *8 NO. 3 VACUUM TRANSMITTING HOSE *9 UNION TO CONNECTOR TUBE HOSE *10 NO...
Categories
WARNING
When removing the fuel-filler cap, loosen the cap slightly and wait
for
any hissing to stop, then remove it
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness
if
ingested. Fuel spray is released when there is pressure in the fuel tank and
the fuel-filler cap is removed too quickly.
read more