Toyota Yaris: Heating / Air Conditioning / Condenser
INSTALLATION PROCEDURE 1. INSPECT COMPRESSOR OIL (a) Remove the suction seal cap. (b) Using a screwdriver with its tip wrapped in protective tape, insert the screwdriver through the suction port and set the VST valve (valve inside suction port) to the open position...
COMPONENTS ILLUSTRATION
*1 NO. 1 AIR CLEANER INLET *2 RADIATOR UPPER AIR GUIDE PLATE *3 FRONT BUMPER ENERGY ABSORBER *4 FRONT BUMPER REINFORCEMENT *5 HOOD LOCK ASSEMBLY *6 UPPER RADIATOR SUPPORT SUB-ASSEMBLY
N*m (kgf*cm, ft...
Other information:
COMPONENTS ILLUSTRATION
*1 REAR SPEED SENSOR *2 NO. 3 PARKING BRAKE CABLE ASSEMBLY
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf)
N*m (kgf*cm, ft...
DESCRIPTION The engine stop and start ECU uses its internal starter circuit to drive the starter drive relay (ST No. 1 relay) and operate the starter. WIRING DIAGRAM
CAUTION / NOTICE / HINT
When the engine stop and start ECU is replaced, read the number of starter operations before replacement and record this number to the new engine stop and start ECU after replacement...
Categories
Before refueling, close all the doors, windows, and the liftgate/trunk
lid, and switch the ignition OFF.
To open the fuel-filler lid, pull
the remote fuel-filler lid release.

To remove the fuel-filler cap, turn it counterclockwise.
Attach the removed cap to the
inner side of the fuel-filler lid.
read more