Toyota Yaris: Heating / Air Conditioning / Compressor

Installation

INSTALLATION CAUTION / NOTICE / HINT PROCEDURE 1. INSTALL BLOWER ASSEMBLY (a) Engage the claws to install the blower assembly. (b) Install the 3 screws...

Components

COMPONENTS ILLUSTRATION *1 NO. 1 ENGINE UNDER COVER ASSEMBLY *2 SUCTION HOSE SUB-ASSEMBLY *3 NO. 1 COOLER REFRIGERANT DISCHARGE HOSE *4 COMPRESSOR WITH PULLEY ASSEMBLY *5 O-ring - - Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...

Other information:

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Horn System

Parts LocationPARTS LOCATION ILLUSTRATION *1 LOW PITCHED HORN ASSEMBLY *2 NO. 1 ENGINE ROOM RELAY BLOCK AND NO. 1 JUNCTION BLOCK ASSEMBLY - HORN RELAY - HORN FUSE ILLUSTRATION *1 HORN BUTTON ASSEMBLY *2 SPIRAL CABLE SUB-ASSEMBLY *3 MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *4 POWER DISTRIBUTION BOX ASSEMBLY *5 DLC3 - - System DiagramSYSTEM DIAGRAM Problem Symptoms TablePROBLEM SYMPTOMS TABLE NOTICE: If the main body ECU (multiplex network body ECU) is replaced, refer to the Registration...

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Power Source Mode does not Change to ON (IG)

DESCRIPTION If the engine switch is pressed with the electrical key transmitter sub-assembly in the cabin, the certification ECU (smart key ECU assembly) receives a signal and changes the power source mode. Related Data List and Active Test Items Problem Symptom Data List and Active Test Power source mode does not change to on (IG) but does change to on (ACC) Power Source Control Power Supply Condition IGP Relay Circuit (Outside) Monitor IGP Relay Circuit (Inside) Monitor IGR Relay Circuit (Outside) Monitor IGR Relay Circuit (Inside) Monitor WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1...